Skip to main content
  1. This guide will show you how to take your already cut Maker Table parts and assemble them into a table just like the one you see here. This guide will show you how to take your already cut Maker Table parts and assemble them into a table just like the one you see here. This guide will show you how to take your already cut Maker Table parts and assemble them into a table just like the one you see here.
    • This guide will show you how to take your already cut Maker Table parts and assemble them into a table just like the one you see here.

  2. Gather all of your CNC cut parts. Set them out on your bench. They may need some final sanding here. Gather all of your CNC cut parts. Set them out on your bench. They may need some final sanding here.
    • Gather all of your CNC cut parts. Set them out on your bench. They may need some final sanding here.

  3. Insert the dowels into your legs. Before you apply the glue fit the legs together to make sure that they line up well, and they fit flush.
    • Insert the dowels into your legs. Before you apply the glue fit the legs together to make sure that they line up well, and they fit flush.

    • After you check for good fit, liberally apply wood glue and press the two halves together. Sometimes a gentle tap with a rubber mallet can help.

    • Have a rag or towel handy to mop up any glue that dribbles out.

  4. Clamp both of your leg halves together.
    • Clamp both of your leg halves together.

    • Follow the instructions on the glue you have used to make sure you allow enough dry time before releasing the clamps.

Finish Line

Eric Schimelpfenig

Member since: 06/09/2015

101 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 54